Link the IPsec Security Association to an IPsec Policy

Use the following procedure to link the security association to an IPsec policy.

Before you begin

The IPsec security association and IPsec policy must exist.

About this task

You cannot delete or modify a security association if the security association links to a policy. To modify a parameter in the security association, or to delete the security association, you must first unlink the security association from the policy. You can only unlink a security association from a policy if the policy does not link to an interface. If a policy links to an interface, you must first unlink the policy from the interface, and then unlink the policy from the security association.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Link the IPsec security association to the IPsec policy:

ipsec policy WORD<1–32> security-association WORD<1–32>

Example

Link the IPsec security association named new_sa to the IPsec policy named newpolicy:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#ipsec policy newpolicy security-association newsa

Variable Definitions

The following table defines parameters for the ipsec policy command.


Variable	Value
`WORD<1–32>`	Specifies the policy ID.
security-association `WORD<1–32>`	Specifies the security association ID.